Pennsylvania voters, take note: if your ballot isn’t dressed properly, you can kiss your vote goodbye. If it’s not sealed in a secrecy envelope before being placed in the main envelope, it won’t be counted.
You’ll also want to make sure to sign and date the back of the envelope before returning it.
Here’s how to do it right.
What’s in the package
When getting your ballot via the mail, you’ll receive a thick envelope from your county election office. Here’s what’s in it:
- The ballot itself
- An instruction card
- A secrecy envelope
- An outer envelope
- A sheet explaining any other ballot questions
Fill out the ballot clearly, using black or blue ink
Ballot designs vary from county to county, and the non-statewide candidates on it will depend on exactly where you live. What does not vary is this: you must use a blue or black ink pen to fill it out.
Also — apologies for triggering PTSD from standardized tests in high school — make sure each oval is darkened fully, and don’t make any marks on the ballot outside those ovals. There may be ovals on both the back and the front of the ballot.
What if you fill out that oval and realize it was the wrong one? Or if your kid or cat knocked your hand while you were doing it and caused a big scribble across the page? You can get a replacement ballot from the county election office.
Place ballot in the ‘secrecy’ envelope
It’s not too hard to differentiate between the two envelopes. The secrecy envelope is the one that’s mostly blank but says “Official Election Ballot” on the front. It’s also the smaller of the two.
Fold up your filled-out ballot and place it inside the secrecy envelope, then seal it. Failure to “dress” your ballot this way will result in it being discarded.
Put it all in the outer envelope
The outer envelope is the larger one, with lots of markings on it.
The wavy election logo will be stamped on the front, next to the “no postage necessary” mark on the top right corner. The front will also say “Business Reply Mail” and will have the address of your county election board. The back will also be covered with wording — that’s part of the next step.
Take the secrecy envelope containing your filled out ballot, and put the whole thing in the outer envelope, then close and seal the flap.
Sign the back of the outer envelope
Give yourself a pat on the back, you’re almost done. Just need to fill out and sign and date the voter declaration on the back.
This certifies your vote is coming from you — and that you are who you say you are: a registered, valid voter in your current district. It also makes sure you understand that once you submit this ballot, you will not be able to vote in person on Election Day (unless you bring in the ballot AND both envelopes to be voided).
You might notice there are two places to sign. One is for people who filled out their ballot themselves, the majority of folks. (You can only have someone else fill it out for you if that’s already part of your voter registration file, or if you get a separate document from the county election board in advance.)
So, put your autograph next to the appropriate X, and write down the date.
Note: Don’t worry too much about your signature matching the one on file. In the same decision that made secrecy envelopes a requirement, the Pa. Supreme Court said a handwriting mismatch alone is not reason enough to disqualify a ballot.
Submit your vote
All that’s left is to deliver it. Just like requesting a ballot, you can do that via U.S. mail or in person — either at your county’s election board office or at a designated ballot drop box or staffed drop-off events.
What if your ballot gets wet?
Let it dry, making sure to keep the envelope flaps open so they don’t seal shut. If it looks fine, like a reasonable person would be able to use it, fill it out and send it in. If not, request a new one at your local election office.
